Header

by: Old Man Roo

Introduction:

I've had this little jigger sitting in the garage for what seems like forever, and finally got around to installing it a couple of weeks ago. For those with full systems, the servo motor that actuates the EXUP valve becomes redundant, but you can't just unplug it & remove it because you'll get a tach error code. Ivan's kit fixes this problem, and is a fully reversible mod.

Installation:

Contents of the kit.



Another view of the components of the kit.



View of EXUP servo motor in situ.



Undo cable tie & fan motor connector.



View of servo motor support bracket from LHS front.



View of servo motor support bracket from LH side.



Remove & unplug servo motor.



Shot of removed motor & bracket.



Another shot of removed Servo motor & parts.



Wiring harness connector disassembly 1.



Connector disassembly 2.



Connector disassembly 3.



Old connector components.



Connector disassembly 4.



Connector disassembly 5.



New connector detail.



Fitting wires to new connectors.



New 3 pin connector end detail.



Eliminator connectors end detail.



Finished.



Last steps:

  1. Refit cable tie(s) and re-connect fan wire.
  2. Turn on ignition & confirm that you have no tach error.
  3. Refit tank etc per Pat's site.

I hope this helps anyone looking to do this mod.

Last Updated: 04-02-2007