View Single Post
Old 03-24-2017, 08:51 PM   #23
Daveaz
Breaking in my FZ1
 
Daveaz's Avatar
 
Join Date: Oct 2016
Location: Phoenix, Arizona
Posts: 60
Smile My studying created a list

2009 FZ1

Maintenance:
Shell Rotella 5W-40 (Full synthetic)
Mobil 1 M1-110A Filter
(4) NGK (3521) CR9EIX

Handling:
120/70ZR-17 Bridgestone Battlax S21 Front / 190/55ZR-17 T30 EVO Rear
Richard Satan666 rear shock adapter
2007-08 R1 rear shock
Tank Grippers

Performance:
17T / 49T (Sunstar 5474) sprockets
130 link (cut to 124) EK 530 ZVX3 NX chain
Pleated air filter (BMC FM456/04)
Two Brothers M2 standard aluminum slip-on w/ P1-X tip ( +/- 101 Db?)
AIS block off plates
Fuel line replacement: 16L 5/16th ID Gates 225psi 16.5 bar EFI hose & EFI hose clamps (Napa)
(2 pr.) EBC HH sintered front Brake pads

Comfort / Ergo: http://cycle-ergo.com/
Foam and seatcover (Dirtroad)
Suzuki Marauder GZ250 Handlebar risers (1.25" Rise, 7/8" bar) About 1" lower
Progrip 699 grips
Ebay China shorty levers
Rearset washer mod
R6 footpegs that sag slightly
Added a helmet lock that replaces the clamp retaining the front brake master cylinder.

Cosmetic:
LED Headlight bulbs (YITA Motor L20-W004 H4 6000K)
Interactive turns / taillight (Ebay, perfect.)
Ebay Flush Mount LED Turn Signals (can't be seen )
Ebay LED Blinker Relay
Swingarm Lic. Plate mount
Black windscreen
Engine crash pad sliders
Delrin Frame Sliders
Delrin Swingarm spool/sliders
Removed factory stickers
Black reflective rim stripes
Headlight turn signal pods (Can not be seen at all )

Labor mods: (As if installing all that stuff isn't enough labor)
Lower front (Raise forks 5-13mm in triple clamp. Started with 8mm)
Take to Ted Rich (Local racer shop) for handling adjustment (Preload rider sag, etc.)
Cut airbox (Lars method)
Remove EXUP
Sync throttle bodies
Apply dielectric grease to elec connectors
When needed: Rebound is Right fork (10 wt. oil,) Compression is left fork (5wt.oil.)

ECU:
Vcyclenut (David) flash with fuel map

Working on fabricating mounts for Hepco & Becker saddlebags.

(Still deciding):
(R6 throttle? Rearsets?)
CF Belly pan with mounting hardware (LEA components)? Too expensive.

Last edited by Daveaz; 02-24-2018 at 03:11 PM. Reason: Revising as I go
Daveaz is offline   Reply With Quote
 
Page generated in 0.04732 seconds with 8 queries